Preparation materials: including flowers, glue gun, hair clips, etc.
Trim the flowers: Choose large and small flowers, divided into main flowers and auxiliary flowers. Leave about 1cm for the main flower and about the width of a hairpin for the auxiliary flower.
Glue the flowers to the hairpin: when spraying the glue gun, glue the small flowers first, then glue the large flowers;
Adjust the flower: Gently adjust the flower position before the glue dries completely;
Cooling glue: Leave to cool and ensure that the glue is completely hardened.
Here is a step-by-step explanation of DIY flower headwear.
1. Prepare materials
Flowers (fresh flowers or artificial flowers)
Glue gun
barrette
Lace headband, etc
Note:
If you are preparing flowers and want to wear your own headgear throughout the day of the wedding, it is best to consult with the florist which flowers are more durable and will last longer.
If you want more patterns, in addition to the basic hair clips and flowers, you can also prepare more PROPS to design your own, such as adding a lace headband or adding some jewelry.
2. Trim the flowers
If you choose fresh flowers, then the stems and leaves of the flowers should be trimmed to make it easier to paste them later.
The flowers selected are generally large and small, divided into main flowers and auxiliary flowers. Cut off the hard stems of the large flower that is the main flower. Trim, cut very close to the bud, about 1cm or so, the small flower stems can be slightly longer, almost to the width of the hairpin.
3. Glue flowers to bobby pins
After the flowers have been trimmed, they can be attached to the bobby pin. This design picture should be planned in advance, you can look at other people's design process and record, you can also draw the effect.
When using a glue gun, start with small flowers and work your way up to large flowers. Pay attention to the use of the process to be careful, because the hot glue gun temperature is high, easy to hurt the hand, and a little glue is enough, after sticking good flowers to press one minute to fix the shape.
4. Adjust the flowers
Before the glue dries completely, you can gently adjust the position of the flowers to make them fit together more perfectly.
Pay attention to nature is the most important, do not make it too neat, too rigid is not good looking.
5. Cool the glue
After the flower fascinator is finished, let it cool for a while to make sure the glue has fully hardened.